We perform the following steps to assure you of quality service.

1- We clean the register covers to remove cooking oil film, nicotine film and other dust-collecting substances.

2- We deep clean the source of the air supply including (where applicable) the blower, squirrel cage, coils, condensation pan and return air supply.

3- The air ducts are then brush vacuumed clean with our exclusive, patented cleaning system. The equipment removes the contaminants that circulate through the air duct system. We will sanitize your air ducts and vents with an environmental safe sanitizer commonly used in hospitals and nursing homes, leaving behind a fresh scent.

4- Finally your system is inspected  to show you where the trouble spots were, and verifies the job was done right!

1. Clean and calibrate the thermostat.
2. Check the refrigerant charge level and add up to 1lb of refrigerant.
3. Check and replace your existing air filter with a new permanent washable filter.
4. Add time release algaecide tablets to the drain pan to keep bacteria from building up.
5. Inspect visible refrigerant lines for leaks.
6. Inspect and test the starting capabilities of the system.
7. Check voltage and amperage draw of your compressor and motor.
8. Check the air temperature for proper cooling and heating.
9. Inspect all accessible duct work for leaks and damage.
10. Lubricate all accessible moving parts.
11. Inspect and adjust the blower and its components.
12. Inspect system safety controls for defects.
13. Inspect drain lines for proper drainage and leaks.
14. Inspect electrical connections, circuit breakers and fuses for proper size and defects.
15. Check for fire hazards.